eNet radio transmitter modules
Disconnecting connection to an actuator
￭
Carry out the same steps as when connecting (see the chapter Connecting channel but-
ton to radio actuator).
The status LED of the actuator flashes quickly for 5 seconds. The actuator is disconnec-
ted from the radio transmitter. The actuator and radio transmitter exit the programming
mode automatically.
If there several connections or scene buttons for an actuator, all the connections must be
disconnected individually.
All On and All Off buttons of a radio transmitter are disconnected automatically as soon as
the last connection to the actuator is disconnected. Manual disconnection is not possible.
Polling button programming
￭
Briefly press the top right and bottom left buttons simultaneously (Figure 5).
All functions are terminated.
Permanent lighting of the green LED for programming as channel button.
Rapid flashing of the green LED for programming as scene button.
Resetting the channel or scene button
The connections to the actuators are disconnected and parameters are reset to default setting.
The connections in the actuators are preserved and must be deleted separately.
￭
Press the top left and bottom right buttons simultaneously for longer than 20 seconds
(Figure 4).
The red status LED flashes after 4 seconds. After 20 seconds the LED flashes faster.
￭
Press the desired button briefly.
The red LED flashes more slowly.
The channel button or scene button has been reset. The setting as channel button or
scene button is retained.
Resetting wall transmitter to the default setting
The connections to the actuators are disconnected and parameters are reset to default setting.
The connections in the actuators are preserved and must be deleted separately.
￭
Press the top left and bottom right buttons simultaneously for longer than 20 seconds
(Figure 4).
The red status LED flashes after 4 seconds. After 20 seconds the LED flashes faster.
￭
Release buttons and press the top left and bottom right buttons simultaneously once
again.
The red LED flashes more slowly for approx. 5 seconds.
The wall transmitter is reset to default setting. All the buttons are set as channel buttons.
7
Disposal of batteries
Remove empty batteries immediately and dispose of in an environmentally friendly
manner. Do not throw batteries into household waste. Consult your local authorities
about environmentally friendly disposal. According to statutory provisions, the end
consumer is obligated to return used batteries.
8
Technical data
Rated voltage
DC 3 V
Battery type
1×Lithium CR 2450N
Ambient temperature
-5 ... +45 °C
7 / 9
32579243
21.06.2019
J082579243
