JUMAR REG-03 Mini, Installation And Maintenance Instruction

Page: 15 / 31

JUMAR REG-03
Mini
WORKING MODES
The controller may work in two working modes („ STOP ”, „ AUTO ”). The change of
the working mode happens when the button is pressed for 3 seconds. on the
regulator's panel. The „ STOP ” mode activates procedures connected with the burner's
putting out i.e. burning off and cleaning. Short press button displays the current
mode.
In the table beneath a short description of particular functions of the burner, activated
depending on the working mode of the driver, is shown.
FUNCTIONS
NAME
FUNCTION
DESCRIPTION
STOP Burner stopped.
FILLING Filling the feeder.
Filling stops automatically after about 10 minutes.
IGNITION
Ignition of pellet. The mode would be automatically changed after
detecting a flame by the sensor.
CLEANING
The cleaning of the burner from he left ashes. The cleaning
function also as a blow down before ignition.
WORK
Heating the boiler up to the set temperature. Showing the actual
power of the burner.
PAUSE
Sustaining the set temperature (if the burner's working mode is in
the mode of continuous work)
BURNING OFF
Putting off the burner. Active in the STOP mode or in the
temporal working mode of the burner.
STANDBY
Standby of the burner for the decline of the temperature of a
hysteresis (if the burner's working mode is in the temporal mode).
NO PELLET
The driver carries out three trials of ignition of the pellet. The lack
of flame may be caused by: the lack of the pellet in the container,
when the big feeder was not filled with the pellets, the flame's
sensor is dirty or broken.
BURNER ALARM
If the temperature of burner rises over the maximum value, the
driver would activate the procedures of the burner's protection.
STB ALARM
Boiler overheat alarm. Burner will be stop. Alarm should be RESET
by user.
- 15 -
MODE
MODE