Operation
48
8 Operation
8.1 Switch on the unit
This section describes how to switch on the device.
v
The unit is connected and ready for operation.
1. Switch the unit on at the mains switch.
All display elements light up briefly, the software boots and starts the
device.
The unit is switched on and ready for operation. It switches to the most
recently activated operating mode, manual mode of operation or remote
control mode. If the auto start function is activated, then the unit starts
directly into the last setting.
If remote control mode is enabled, the device cannot be operated directly.
First disable remote control mode.
8.2 Switch off the unit
This section describes how to switch off the device.
The device is switched on.
1. Stop a running temperature control application.
If a cooling machine is connected, the cooling symbol flashes and the
cooling machine is shut down.
Do not switch off the device until the cooling symbol stops flashing and the
device is in standby mode.
2. Switch the device off at the mains switch.
The device is switched off.
8.3 Configuring setpoint temperature
Device is running the temperature control application to the configured setpoint
temperature. The factory setting is 10°C. The setpoint temperature can be
changed while the temperature control application is running. The set value is
saved.
The unit is switched on.
1. Press one of the arrow keys briefly.
The display switches from the actual value display to the setpoint display.
The digits before the decimal point flash.
2. Use the arrow keys to set the value before the decimal point and confirm
with
[OK]
.
Summary of Contents for CORIO CP-1000F
Page 72: ......
