EN
66
TROUBLESHOOTING
Error messages
Message
Type of message
Event
Action
Empty display.
Check that the main switch is set to OFF.
The battery may be discharged on delivery. Switch off the robotic lawn
mower, put it in the charging station and start it.
Press START on the keypad to start the robotic lawn mower. If the robotic
lawn mower does not start, check for error codes and rectify the fault.
If the display is empty when pressing a button, put the robotic lawn mower
in the charging station. Wait 5 minutes and then follow the above steps.
The robotic lawn mower cannot
go into the charging station.
Check that the border wire in front and under the charging station is
straight.
Check that the charging station is positioned according to the instructions.
The robotic lawn mower goes in
circles along the border wire to
the charging station.
Check is there is a high tension cable near or under the border wire. If so,
move the border wire to avoid this area.
Flashes
Information message.
Charging.
Correct function.
Steady
Information message.
On way to charging station.
Correct function.
Warning message.
Too low battery voltage for
normal mowing.
When the battery voltage is low the robotic lawn mower normally goes
back to the charging station.
Carry the robotic lawn mower to the charging station if it has stopped on
the lawn.
Flashes
Warning message.
The robotic lawn mower is
uplifted.
Check whether the robotic lawn mower is uplifted because of long grass
(longer than 60 mm). If so, mow the grass with a normal lawn mower
before starting the robotic lawn mower again.
Check that the robotic lawn mower is not blocked.
Flashes
Warning message.
The appliance does not receive a
signal from the border wire.
Check that the status lamp on the charging station is blue.
If the status lamp is not on, check that the charging station is connected to
the mains.
Om the status lamp is red, check that the border wire is connected to the
charging station.
When using for the first time after a power failure, carry the robotic lawn
mower to the nearest border wire.
Check that the same signal (S1 or S2) is set on the charging station and on
the touch screen.
Flashes
Warning message.
The robotic lawn mower is, or
has been outside the border
wire.
If the display shows OUTSIDE even though the robotic lawn mower is inside
the mowing area, check that the border wire is correctly connected to the
charging station.
If the robotic lawn mower is outside the mowing area, lift it into the
mowing area and restart it.
If the robotic lawn mower comes outside the mowing area at a corner,
move the border wire to make the corner rounder.
If the robotic lawn mower comes outside the border wire several times at
the same place, check if there is a high tension cable near or under the
ground. If so, move the border wire if possible to avoid this area.
Rotates
Information message.
Mowing in progress.
Normal function.
Summary of Contents for Meec tools 001-115
