EN
67
Troubleshooting charging station
Status lamp
Description
Blue lamp on.
Normal.
Flashing blue lamp.
The charging station’s inner wire is damaged. The border wire is OK.
Flashing red lamp.
The border wire is damaged. The charging station’s inner wire is OK.
Flashes blue and red lamp.
Both the border wire and the charging station’s inner wire are damaged.
Error codes
Message
Type of message
Event
Action
EF 01
Warning message.
The obstacle sensor is blocked.
Check if an object has fastened between the casing and the
chassis.
EF 02
Warning message.
The robotic lawn mower is tilting.
Check if the gradient of the ground is too steep and if necessary
move the border wire. The robotic lawn mower can normally
handle moderate gradients without any problems.
EF 03
Warning message.
The robotic lawn mower has tipped over.
Move the robotic lawn mower to level ground and restart it.
EF 04
Warning message.
The robotic lawn mower has got stuck.
This message is shown when the collision sensor is activated
more than 10 times in 1 minute. Check if the robotic lawn
mower has got stuck between obstacles such as trees, or
bushes etc. Remove the obstacles, or move the border wire to
avoid this area.
EF 05
Warning message.
The robotic lawn mower is uplifted.
Check whether the robotic lawn mower is uplifted because of
long grass (longer than 60 mm). If so, mow the grass with a
normal lawn mower before starting the robotic lawn mower
again.
Check that the robotic lawn mower is not blocked.
EF 06
Warning message.
The robotic lawn mower is, or has been
outside the border wire.
If the display shows OUTSIDE even though the robotic lawn
mower is inside the mowing area, check that the border wire is
correctly connected to the charging station.
If the robotic lawn mower is outside the mowing area, lift it into
the mowing area and restart it.
If the robotic lawn mower comes outside the mowing area at a
corner, move the border wire to make the corner rounder.
If the robotic lawn mower comes outside the border wire
several times at the same place, check if there is a high tension
cable near or under the ground. If so, move the border wire if
possible to avoid this area.
EF 07
Warning message.
The robotic lawn mower does not receive
a signal from the border wire.
Check that the status lamp on the charging station is green.
If the status lamp is not on, check that the charging station is
connected to the mains.
Om the status lamp is red, check that the border wire is
connected to the charging station.
When using for the first time after a power failure, carry the
robotic lawn mower to the nearest border wire.
EF 08
Warning message.
Too low battery voltage for normal
mowing.
When the battery voltage is low the robotic lawn mower
normally goes back to the charging station.
Carry the robotic lawn mower to the charging station if it has
stopped on the lawn.
EF 09
Warning message.
The drive motor is blocked.
Switch off and restart the robotic lawn mower. Contact
customer service if the fault persists after restarting the robotic
lawn mower.
EF 10
Warning message.
The mowing motor is blocked.
Switch off and restart the robotic lawn mower. Contact
customer service if the fault persists after restarting the robotic
lawn mower.
Summary of Contents for Meec tools 001-115
