EN
13
3. Note which straps are loose.
Take off the helmet and shorten the straps
to fit.
– To shorten the chin strap, hold the
clasp in one hand. Then pull the
strap through the clasp.
– To shorten the back strap, pull out
the strap from the back of strap 2.
Hold the helmet in one hand. Hold
the other hand in the straps where
they pass under the chin. Pull from
side to side to adjust all four straps
evenly sideways.
4. The helmet should sit straight and firmly
on the head.
– To put the helmet lower down over
the forehead, shorten the chin strap
and extend the back strap.
– To put the helmet higher up over the
forehead, extend the chin strap and
shorten the back strap.
FINAL CHECK
Check the tension of the straps by putting the
helmet on the head and fastening the clasp.
Open the mouth wide, the strap should feel
tight against the chin. Try to lift the helmet at
the front and back. If the helmet can be lifted
shorten the corresponding strap. It should
not be possible to move the helmet too far
forwards or backwards.
FIG. 3
MAINTENANCE
CLEANING
Clean the helmet when necessary with hot
water and a mild detergent.
A. Front
1. Chin strap
2. Strap tensioner
3. Clasp
4. Back strap
FIG. 2
USE
ADJUSTING
The helmet must be well adjusted to provide
full protection. The helmet is properly adjusted
when it does not move forward, backwards or
sideways when fastened. If the helmet can be
wobbled forward or backwards the straps, and
if necessary the clasp on the back, must be
adjusted.
NOTE:
• Check the adjustment of the helmet
every time it is used.
• It should not be possible to take off the
helmet without unfastening the clasp.
• The straps should be adjusted so that
they do not cover the ears and so that
the clasp is turned away from the chin.
• If the helmet cannot be adjusted to suit
the user, use another helmet.
Straps and clasp
The helmet has a clasp that is easy to fasten
and unfasten without adjusting. The straps
must be evenly tensioned.
1. Put the helmet firmly on the head and
fasten the clasp.
2. Adjust the clasp on the back so that the
helmet fits comfortably (sufficiently tight)
round the head. Turn clockwise to tighten,
and anticlockwise to loosen the clasp.
