ENGLISH
18
the socket and replugged after a few seconds. After that the fuse is reset and the pump will start
with the self test (see above).
The level sensor can be placed at five different heights to set the start level. The level sensor is
held in place by a clamping screw.
MAINTENANCE
Before each use
Action
Design
Inspect the casing and cables for damage.
Visual inspection.
Check that the level sensor is attached correctly.
After each use
Action
Clean the pump.
External cleaning
Rinse with clean water.
Remove stubborn stains using a brush and detergent.
Lower the pump into a container of clean water and run for a short time to flush the inside of the
pump.
Cleaning the intake
Clean the inlet.
Open the pressure pipe connection and remove any fibres that have wound around the rotor shaft.
Remove stubborn stains using a brush and detergent.
NOTE:
Before using the pump again, allow it to stand in the liquid for a while to prevent any deposits and
residue from clogging it.
Storage
If there is a risk of frost, dismantle and clean the pump and its accessories and store in a frost-free place.
The pump and its accessories contain water, which means that they may burst if the water freezes.