JUKI SC-920, Engineer'S Manual, Page: 49 / 75

– 45 –
Selection of the optional input/output function (Function setting No. 12)
Select function setting No. 12 with the operating procedure of function set-
ting procedures 1) through 3).
Select the items of "End", "in" and "ouT" with keys and .
[When "in" is selected]
The port number is displayed on indicator . Specify the input port with key
or . Or, specify the function of input port using key or .
Function code and abbreviation are displayed alternately on indicator .
(For the relation between signal input No. and connector pin array, refer to
the separate list.)
[When "ouT" is selected]
The port number is displayed on indicator . Specify the output port with
key or . Or, specify the function of output port using key or .
Function code and abbreviation are displayed alternately on indicator .
(Refer to the separate table for the relation between the signal output num-
bers and the connector pin configuration.)
* Example) Setting the thread trimming function to the optional input port 1
1. Select function setting No. 12 with the operating procedure of function
setting procedures 1) through 3).
2. Select the item of "in" with keys and .
3. Select the port of 901 with key .
4. Select the thread trimming function, "TSW" with keys and .
5. Determine the thread trimming function, "TSW" with key .
6. Set ACTIVE of the signal with keys and .
Set the display to "L" when the signal is "Low" and performing thread
trimming, and set the display to "H" when the signal is "High" and per-
forming thread trimming.
7. Determine the aforementioned function with key .
8. Finish the optional input with key .
9. Select the item of "End" with keys and to return to the function set-
ting mode.
Lighting alternately
<=
<=
1 2 T P o _
0
_ n i _
9 0 n E _ d
0 9 1 * * *
1 9 2
5 9 1 * * *
T u o _
5 9 3
1 2 T P o _
0 9 0 _ n i _
0 9 1 o n P
L 4
0 9 1 S T W
0 9 1 L 4
H 4
0 9 2 o n P
0 9 0 i n
n E d
* Name of option
is displayed.
* Name of option
is displayed.