– 51 –
116
Selection of
When the IP-110 is connected, switch selection is performed
U
0 to 6
65
corner teaching
to start in-corner sewing in the case of corner pattern sewing.
start switch
0: No function
1: Left needle selector switch
2: Right needle selector switch
3: Teaching switch
4: Optional switch
5: Knee switch, presser lifter switch
6: No function (Don’t care.)
*
When 1: left needle selector switch, 2: right needle selector
switch, or
3: teaching switch is selected for the in-corner selector
switch, set
No.111 unilateral needle selection function (corner
pattern) at 0 (function disabled), without fail.
*
Setting is possible only if LH-4168 or LH-4188 is selected for
the machine head.
117
Selection of
When the knee switch is connected, selection is performed
U
0/1
66
presser lifter
to stop/start the automatic presser lifter function by means
switch function
of the knee switch.
0: OFF The automatic presser lifter is stopped with the
knee switch.
1: ON The automatic presser lifter is used with the
knee switch.
*
Setting is possible only if LH-4168 or LH-4188 is selected for
the machine head.
*
When using this function, it is necessary to set up the
presser lifter switch half-needle compensation function
(No. 106) to Position 0 (function disabled).
118
Grease up error
In the case of grease-up error (E220, E221), this error is
U
0/1
66
reset
cleared by setting the setup description at 1.
0: Normal condition
1: Grease-up error reset when the power is turned on for
the next time (After grease-up error has been reset, this
function is also canceled.)
*
Prior to resetting the grease-up error, grease-up treatment
is always needed.
*
Setting is possible only for the machine head (part of the
LH-4100 or LH-3500 Series) where grease-up treatments
are needed.
120
Main shaft
Main shaft reference angle is compensated.
U
–35 to 35
°
66
reference angle
compensation
121
Correction of
Angle to detect UP position stating is compensated.
U
–15 to 15
°
66
upper position
stop angle
122
Correction of
Angle to detect DOWN position stating is compensated.
U
–15 to 15
°
66
lower position
stop angle
125
Designation of
When reverse stitching is started with the reverse stitching
S
200 to
66
reverse stitching
switch or the like, the number of revolutions at the machine
maximum
speed
head is reduced to the specified speed.
(rpm)
(This function becomes valid when the DDL-9000A is selected.)
6
1
1
5
7
1
1
0
8
1
1
0
0
2
1
1
2
-
1
2
1
2
2
2
1
0
No.
Item
Description
Start level Setting range
Indication of
function setting
Ref.
page
o
o
∗
∗
Do not change the set values with asterisk (*) mark as they are functions for maintenance. If the standard set value set at the time
of delivery is changed, it is in danger of causing the machine to be broken or the performance to be deteriorated.
(Descriptions of setting in this list are the standard values at the time of delivery of DDL-9000A.)
However, contents of function setting are subject to change for improvement of function and performance without notice.
o Any version with the o mark is indicated when the LH-4168, LH-4168D, or LH-4188 machine head is selected.
o
5
2
1
0
0
3 3
