– 67 –
WARNING :
Turn �FF the power before starting the work so as to prevent accidents caused by abrupt start of the sewing machine.
Trouble
Cause
Checking
Corrective measures
From the previous page
3-3) Moving knife stops during operation.
3-A) Thread is too thick.
Use thread within the specified value.
3-B)
Thread trimmer timing is excessively
retarded.
Refer to “2.-(17)-6) Thread trimmer cam timing”.
3-C) Needle thread tension is too high.
Decrease the tension of the thread tension No. 1.
3-D) Tension of the bobbin thread is too high.
Adjust the tension of bobbin thread.
3-E) Knife pressure of the counter knife is too
high.
Refer to “2.-(17)-4) Adjusting the knife pressure”.
3-F)
Initial position of the moving knife is ex
-
cessively advanced.
Refer to “2.-(17)-6) Thread trimmer cam timing”.
3-G) Thread is not cut sharply.
Refer to causes “Thread cannot be trimmed” and
“Thread remains uncut after trimming”.
3-4) Needle thread is not caught.
4-A) Stitch skipping at the last stitch.
Refer to “2.-(6) Needle-to-hook timing”.
4-B) Check the thread trimmer cam timing.
Refer to “2.-(17)-6) Thread trimmer cam timing”.
4-C) Top end of the moving knife is broken or
has burrs.
Replace the moving knife with a new one.
3-5) Bobbin thread is not caught.
5-A) Stroke of the moving knife is small.
Refer to “2.-(17)-3) Vertical position of the moving
knife”.
5-B) Check the routing of bobbin thread.
Correctly thread bobbin thread.
5-C) Top end of the moving knife has broken
or been scratched.
Replace the moving knife with a new one.
5-D) Check the height of moving knife.
Adjust the height of moving knife.
5-E) Thread trimming is performed at the po-
sition where there is no sewing product.
Perform thread trimming while pulling sewing product
in the feed direction.
To the next page
海外講習会用121122 LU-2810(-7)̲EM
Summary of Contents for LU-2810 Series
