Judo FIMAT JFXL-M 1 1/2, Installation And Operating Instructions Manual

Page: 19 / 28

JUDO FIMAT 19
Fault
6. Fault
The opening of the units and the replace-
ment of the water pressure charged parts
may only be effected by authorized
personal in order the ensure the unit
security and its tightness.
The occurrence of a failure inside the device
will be indicated by the red control lamp.
Deleting the error message:
Disconnect the power supply from
the socket. Plug it back in after
approx. 5 seconds!
Help with faults:
Fault Cause Remedy
Permanent acoustic
signal sounding. The DIP-switch was set
incorrectly. Correct the position of the DIP-
switch! (see chapter “Setting the
backwashing interval”)
Red control lamp flashes
and acoustic signal
sounding. Electrical or mechanical
failure. – Delete the error message!
– Start backwashing again by
using the manual pushbutton!
If failure is occurring again:
Remove mains plug from the
socket.!
– Inform the fitter or nearest
customer service centre!
– Close ball valves!
All three control lamps
flash. Services is necessary. See chapter “Warranty and ser-
vices”!
Backwashing water
continues running. Flushing valve not fully
closed. – Start backwashing again by
using the manual pushbutton!
Dirt in the flushing valve.
Water flow rate falls. Screen is blocked.
Leaks in the filter. – Remove mains plug from the
socket!
– Close ball valves!
– Inform the fitter or nearest
customer service centre!
Filter cover becomes
turbid. Filter hood has been
exposed to high tempera-
tures or solvents.
Hairline cracks on the
filter hood.