JTS UF-20R/5, Instruction Manual

Page: 19 / 48

19
EnglishEnglish
item
User Name
has been called up, the
first character position is selected:
User Name
U F-20
Char:1/10
Fig. 9
Turn the knob PUSH  / CONTROL to select
the desired character Press the knob to go
to the next character position Press the but-
ton SETUP to save the name The main menu
reappears
5) For a reset to the factory settings, select the
menu item
e. Reset
A message appears
warning the user that resetting will erase any
data stored:
This will erase all data
from receiver’s Internal
Storage
Press S 2 Sec to Reset
Fig. 10
To exit, press the button EXIT; to reset, keep
the button SETUP pressed for 2 seconds until
Erasing...
appears
3.5 Setting the
transmission frequency
Before switching on the corresponding wireless
microphone (JSS-20 / 5) or the corresponding
pocket transmitter (UF-20TB / 5), set the receiver
to an interference-free transmission frequency
There are three methods to do this:
1 The transmission frequency can be ad-
justed manually between 530 000 MHz and
605 000 MHz (chapter 3 5 1)
2 For operating multiple audio transmission
systems at the same time (chapter 3 5 2),
there are 15 groups with up to 63 channels
in each group (refer to the table starting on
page 46) In ideal conditions, all channels
from a group can be used for audio transmis-
sion at the same time
The scan function can be used to deter-
mine the channels being used for transmission
by other systems (chapter 3 5 3) These chan-
nels will be skipped during channel selection
3 Preferred frequencies can also be saved to
six user-defined frequency groups (chap-
ter 3 5 4), e g when operating multiple audio
transmission systems in varying locations
3.5.1 Setting the frequency manually
1) Call up the frequency setting via the menu
item
1. Frequency
of the main menu:
Setup Frequency
532 .625MHz
G:1 CH:1
Fig. 11
2) Turn the knob PUSH  / CONTROL to set the
frequency in steps of 1 MHz
3) For fine adjustment in steps of 0 025 MHz,
turn the knob so that the digits after the deci-
mal point are highlighted Then turn the knob
If the frequency is identical to the frequency of
a channel in a group, the group and channel
numbers are indicated in the lower line
4) Press the button SETUP to save the frequency
adjusted
3.5.2 Selecting a frequency from a group
The easiest way to operate multiple audio trans-
mission systems at the same time is to select
the frequencies for the systems from one of the
15 groups:
1) Call up the group and channel selections via
the menu item
2. Group/Channel
:
Setup Group
G: 14 CH:62
602.175 MHz
Fig. 12
2) Turn the knob PUSH  / CONTROL to select
the group
3) Press the knob to highlight the channel num-
ber Then turn the knob to select the channel
The corresponding transmission frequency is
indicated in the lower line
4) Press the button SETUP to save the setting
3.5.3 Scan function
Before a transmission channel is selected, the
scan function can be used to determine if other
transmission systems are currently transmitting
on the channels of the receiver UF-20R / 5 or
UF-20S / 5 The channels already used will be
skipped during channel selection
Call up the selection menu for scanning via the
menu item
4. Scan
of the main menu: