www.modellmarkt24.ch
The rudder servo linkage connection is now ready to be
accomplished using the same technique as the elevator
linkage. These guides will be mounted horizontally to the
side of the fuselage. Just as the ones used for the elevator,
you will see the cutouts pre made in the fuselage. Do not glue
them in until the Z bend and straight link are both secured
to the carbon linkage using REGULAR CA and heat shrink.
Locate the motor mount and make sure that all four ends of
the mount line up to the indents made in the foam. Also
when glueing on the mount as shown above, make sure is is
pressed directly up against the foam and made flush. Next,
bend the tabs over on each side 90 degrees and give them a
hard press against the foam. You may wish to add glue to
the tabs.
www.modellmarkt24.ch