www.modellmarkt24.ch
connected to the EZ connector on the servo arm. This is
because heat shrinking still needs to be done and if the
guides were glued in while heat shrinking was attempted, it
may be too close to the foam causing the foam to melt.
Once the servo is centered, and both sides of the linkage are
glued and tightened with heat shrink, you can now glue in
place the guides for the linkage. It is best to put a small bit of
glue inside the cutout then place in the guide. Make sure that
they are all standing straight up and flush with the fuselage.
If the linkage is getting stuck in one of the holes, use
sandpaper on the linkage to ever so slightly slim the carbon.
www.modellmarkt24.ch