www.modellmarkt24.ch
notice there is a cutout for this piece. Test fit, glue, then
repeat for the other aileron.
Locate the triangular joiner that will be placed on the
underside of each aileron. Once you make sure that it fits
clean and snug into the cutout, you can glue this piece in and
repeat to the other side.
With the joiner in place, you can now begin the process of
bracing the aileron. This will include four carbon fiber rods
in the configuration shown above. The lengths for each are
190mm, 170mm, 140mm, and 155mm. The carbon rods will
www.modellmarkt24.ch