7
H:\0 - Quality Documents\2 Department\Tech Serv\Application tooling\Presses\AP-K2N\TS010-00 AP-K2N Operation
Manual.doc
3.3 Mounting the Terminal Reel
Mount the terminal reel to the reel hanger so that the
terminal barrels are facing the reel guide, then feed the
terminals through the terminal guide to the applicator.
Mounting the MK-L Applicator
Step 1
Push down the tension lever and engage the hook with
the feed plate so that the pressure pad rises. Feed the
terminal strip between the guide rails.
Step 2
Place the first terminal at the correct crimping position.
Release the hook from the feed plate to allow the
pressure pad to apply pressure on the strip.
Mounting the MKS-L or MKS-LS
Applicator
Step 1
Rotate the wing bolt clockwise to raise the pressure
plate. Feed the terminal strip between the guide rails.
Step 2
Place the first terminal in position so that the terminal is
centralised over the anvil. Rotate the wing bolt counter-
clockwise to lower the pressure plate so that pressure is
applied to the terminal.