- 3 -
Low-Cost Programmable Transmitters P5310, P5311 with LHP Communication
1. General instructions and information
1.1 Symbols used
- Warning symbol; for safe use proceed according
to the instructions
- The symbol CE approves conformity of the product
with legal requirements
- Symbol ”Output“
- Symbol “Power supply”
- T
his product does not belong to public waste
and it is
subjected to separate collection
- The product meets requirements for explosion
hazard environment according to the further
specification
LHP
- Remote communication protocol for reading
and changing of the configuration
1.2 Safety cautions and warnings
The transmitter shall be powered from a safe voltage
source that meets all requirements of the standard
EN 61010-1 and installed in compliance with national
requirements and standards providing safety.
The equipment may only be installed by a qualified personnel
who are familiar with national and international laws, directives,
standards and with the instructions manual. The instrument
may not be used for other purposes than as specified in this
instructions manual.
For elimination of a risk of injury from electric shock or fire
the maximum operational parameters of the instrument may
not be exceeded, particularly range of operating temperature
because of exposure to heat from connected or surrounding
technological equipment must not be exceeded!
The transmitter should be installed in suitable environment
without any direct sunlight, occurrence of dust, high
temperatures, mechanical vibrations and shocks and protected
against rain and excessive moisture.
1.3 Scope of delivery
With the product is delivered:
- Manual for installation, operation and maintenance
- Certificate of calibration (only with calibrated transmitters)
- Copy of EC certificate on type examination ATEX
(only transmitters for explosion hazard environment)
1.4 Description of the delivery and packing
The product is packaged in a protective cover and provided
with an identification label with a mark of the output control.
The product must not be exposed to direct rain, vibrations and
shocks during transport.
1.5 Storage
The products shall be stored at temperatures from -40 to
+80 °C without condensation of water vapours.
1.6 Installation and commissioning
During installation, commissioning, operation and maintenance
follow the instructions in chapter 4.
1.7 Spare parts
Any of the compact parts of the product can be also ordered
as a spare part if there are not required special procedures or
technological operations for the exchange.
1.8 Repairs
Products are repaired by the manufacturer. The products for
repair should be sent with description of the fault or defect in
a packing that guarantees damping of shocks and vibrations
and protects against damage during transport.
1.9 Warranty
Products are covered by a warranty for a period of 3 years
from the delivery date on the delivery note. The manufacturer
guarantees technical and operational parameters of the
products within scope of the applicable documentation.
Warranty period is specified with individual items and begins
from the day of takeover of the goods by the purchaser or
delivery to the carrier. Any claims concerning to defects of the
goods together can be filed in writing with the manufacturer
within the warranty period and the claimed product shall be
presented. The claiming party shall give identification of the
product, number of the delivery note and description of the
fault or defect.
The manufacturer is not responsible for any defects caused
by improper storage, incorrect connection, damages caused
by external effects, in particular by effects of factors with
excessive values, unqualified installation, improper operation
or common wearing.
2. End of service and disposal
2.1 End of service
Dismounting and disposal of the device is possible
after disconnecting of power supply voltage.
2.2 Disposal
The product does not contain any environmentally
harmful parts. When disposing the packing and
destroyed or irreparably damaged product proceed
according to the local regulations.
