JRC jue-87, Instruction Manual, Page: 192 / 230

4-14
4.3.3 ERROR Window
The examples of message of ERROR window are listed in Table 4.3.3.
Fig.4.3.3 ERROR Window
Table 4.3.3 ERROR Message
ERROR Message Cause Countermeasure
Cannot create the new file. The capacity of the USB
drive is not enough. Delete unnecessary file or use the
other USB drive.
Confirm the file name. The specified file name is
wrong or it doesn't exist. Enter correct file name.
Distress Button is disconnected.
Check the connection.
DTE failed to initialize the flash
memory. Re-boot the DTE. If same message
is displayed again, the DTE might
have a failure.
DTE was unable to complete the
format. Please remove the USB
drive.
Error on System Information
Writing
File ERROR! Process aborted!
File can’t be open
It seems that the restoration of the
file is difficult. Taking backup of
important document is highly
recommended.
Press ENTER key to retry.
Printer is not ready. Confirm the
paper and on-line. The message is not printed
out. Press Esc key to clear the window,
then confirm the loading of roll
paper and the setting of the printer
by
“Set up” command.
Remote Distress Button is
disconnected. Check the
connection. Connect the Remote Distress Button.
SA Button No. is connected
incorrectly. Check the connection.
SA Button No. is disconnected.
Check the connection.
Same name already exists.
Confirm the file name. The file name is same at the
other file. Use the other file name.
SB Controller is disconnected.
Check the connection.
ERROR
Diskette drive not ready.
Insert diskette and press ENTER key.
F10: Previous