JRC JSS-2250, Instruction Manual

Page: 91 / 220

Operation
4-41
5
55
.
..
After sending an acknowledgement
message, changes the working frequency
and tunes the antenna.
6
66
.
..
When acknowledgement is finished, the
status display is displayed.
Start communications using the handset.
- After completing the DSC call sequence specifying the ARQ or FEC, the telex
mode is set to the equipment. Then the telex communication can be started
with the data terminal.
- When Unable (unable to comply) is selected in the received message handling
menu, the following popup screen opens. Select a reason to insert in the
message.
No reason/ No reason.
Temp no oper/
The operator is temporarily away.
Busy/ Busy.
EQP disabled/
The equipment has been disabled.
Barred/ The station is closed.
Unable FRQ/
The proposed frequency cannot be used.
No oper/
Operator is not present. Unable mode/
The proposed mode cannot be used.
- When New CH (change working frequency) is selected in the received message
handling menu, the following popup screen opens. Enter an appropriate
working frequency.
- When Cancel is selected in the received message handling menu, the previous
screen reappears.
Note
TEL
2065.0
2065.0
RX kHz
TX kHz
W K R s c a n b a n d s :
2 4 6 8 1 2 1 6 ( M H z )
I D 4 3 1 0 0 1 2 3 4 T I M E 2 3 : 5 9 ( U T C )
P o s 8 9 ﾟ 5 9 . 0 1 2 3 ' N
1 7 9 ﾟ 5 9 . 6 7 8 9 ' E @ 2 3 : 5 9 ( E X T )
S I G
I D 4 3 1 0 0 1 2 3 4 T I M E 2 3 : 5 9 ( U T C )
P o s 8 9 ﾟ 5 9 . 0 1 2 3 ' N
1 7 9 ﾟ 5 9 . 6 7 8 9 ' E @ 2 3 : 5 9 ( E X T )
T E L R x : 2 0 6 5 . 0 / T x : 2 0 6 5 . 0 k H z
R o u t i n e i n d i v i d u a l A C K
S t a g e : A c k n o w l e d g e d
T i m e : 0 . 8 m i n a f t e r c a l l i n g
C a l l - F : 2 1 7 7 . 0 / 2 1 7 7 . 0 k H z
W o r k - F : 2 0 6 5 . 0 / 2 0 6 5 . 0 k H z
[ C a n c e l ]
W K R s c a n b a n d s :
2 4 6 8 1 2 1 6 ( M H z )
[ C a n c e l ]
T x
T