JRC JSS-2250, Instruction Manual

Page: 76 / 220

Operation
4-26
(2) Setting the ITU channels
■
Procedure
■
1
11
.
..
After setting the TEL or CW communication
modes, pressing the
CH key opens the
status display for the ITU channel mode.
2
22
.
..
Input the channel by using the numeric
keypad.
When 4 is input using the numeric
keypad, it appears on the far right
as shown in the screen on the right.
3
33
.
..
Input the rest of the digits and press ENT.
The input ITU channel frequency is displayed
and the settings are complete.
- See the appendix "11.4 ITU channel list (TEL/CW/TLX)" for a list of
pre-installed ITU channels and their frequencies.
- Besides doing settings with the numeric keypad, settings can also be done with
the jog dial.
-
The above operation is unavailable in the telex mode. The ITU channel in the
telex mode is set with the controller menu 5.2 ITU channel list, or the data
terminal menu operation, as Tune Î ITU channel set.
Note
Note
TEL ITU- 4
13077.0
12230.0
RX kHz
TX kHz
W K R s c a n b a n d s :
2 4 6 8 1 2 1 6 ( M H z )
I D 4 3 1 0 0 1 2 3 4 T I M E 2 3 : 5 9 ( U T C )
P o s 8 9 ﾟ 5 9 . 0 1 2 3 ' N
1 7 9 ﾟ 5 9 . 6 7 8 9 ' E @ 2 3 : 5 9 ( E X T )
S I G