JRC JSS-2250, Instruction Manual

Page: 59 / 220

Operation
4-9
4.2.4 Communicating in CW mode
Use a CW keyer to communicate in CW mode.
■
Procedure
■
1
11
.
..
When operating on a controller without
access rights (OCC is displayed), press the
jog dial to obtain the access rights.
Unless the controller with access rights is being
used, the access rights are acquired and the OCC
display on the screen disappears.
2
22
.
..
Press the CW key.
¾ The communication mode is set to CW.
¾ Pressing the CW key again turns the
power to the PA on and off.
¾ If the power to the PA is on, TXON is
displayed as shown at right.
3
33
.
..
Set the frequency for making calls in CW
mode.
-
The frequency is set on the receiving
status in the status display. For
details, see "4.3.1 Setting the
communication frequencies" and
"4.3.2 Setting the communication
channels".
-
See the frequency for making calls
in the appendix "11.4 ITU channel
list (TEL/CW/TLX)".
4
44
.
..
Adjust the volume of the loudspeaker by
turning the volume control.
5
55
.
..
Turn the RF GAIN control to an appropriate
reception level.
Note