JRC ALPHAMIDICOURSE Mk2, Installation And Operation Manual

Page: 30 / 99

30 | Installation Instructions
1.5.3 Dip Switch Settings Control Box Part 2
ICNT
S3
Default Details Function Read
Timing
Remarks
NO.1 [OFF] Timer Start Up [OFF] : No [ON] : Yes Start Up
NO.2 [OFF] Talker ID of
"ROT" Sentence
[OFF] : "HE" [ON] : "TI" Start Up
NO.3 [OFF]
Rate of Turn
Scale for Analog
meter
NO3.[OFF],
NO4.[OFF] :
Max
30.0˚/min.
NO3.[ON]
NO4.[OFF] :
Max 120
.0˚/min
Start Up
NO.4 [OFF]
NO3.[OFF],
NO4.[ON] :
Max
300.0˚/
min.
NO3.[ON]
NO4. [OFF] :
DO NOT SET
NO.5 [OFF]
Ban or Permit of
an "ROT"
Sentence Output
Valid at time of external sensor (standard)
selection
Start Up
[OFF] : Disable [ON] : Enable
NO.6 [ON] Alphatron or other [OFF] :No [ON] : AlphaMidiCourse Start Up
NO.7 [OFF] Unit check mode
(For factory only)
[OFF] : No
[ON] : Yes Start Up
NO.8 [OFF] Buzzer stop
contact output
[OFF] : No
[ON] : Yes Start Up
Table: ICNT Board Dip Switch S3 assign
ICNT
S4
Default Details Function Read
Timing
Remarks
NO.1 [OFF] Do Not Touch - -
NO.2 [OFF] For DGC-01 or
not
[OFF] : For Single Gyro System
[ON] : For DGC-01 Control Unit
(Double Gyro System)
Start Up
*1
NO.3 [OFF] Do Not Touch - -
NO.4 [OFF]
Alarm detection
time for Main
Power
[OFF] : 300ms
[ON] : 2sec
Start Up
Fail / Power Unit
fail
NO.5 [OFF] THS
sentence output
[OFF] : Disable
[ON] : Enable
Start Up
NO.6 [OFF] Connection to
DGC-01 or not
[OFF] : For Single Gyro System
[ON] : For DGC-01 Control Unit
(Double Gyro System)
Start Up
*1
Table: ICNT Board Dip Switch S4 assign
*1 Setting for DGC-01 internal board is S4-2: ON and S4-6: ON
Setting for Expanded type connection to DGC-01 is S4-2: OFF and S4-6: ON
* For SCC Board check mode : S1, S2, S3 all [ON]
* For ICIF Board check mode : S1, S2 all [ON] S3 (except No.8 all [ON]