o
If successful the GPS will reply “Fence Alarm Setting OK”
o
Note in the above command that the radius is set to 1. This is because it automatically
multiplies it by 100 so in the above example the RADIUS is 100 meters. If you set the
variable to 5 the RADIUS of the Geo-Fence circle would be 500 meters.
o
The IN/OUT option allows you to alarm if the vehicle goes IN the Geo-Fence zone or
OUT of the Geo-Fence zone. You will generally use OUT for this.
o
The Alert-Type (Report Mode) can be 0 or 1
0 = GPRS only alerts (only works if you have data on)
1 = SMS + GPRS alert (this is the one we use as we don’t have data enabled and
it sends you an SMS if the vehicle leaves the circle
Check the Geo-Fence status
Check the Geo-Fence is set correctly by sending an SMS with “
FENCE#
” and it will return the
status of the Geo-Fence including the Lat/Long, Radius, Status and Report Mode
Remove the Geo-Fence
To remove the Geo-Fence send an SMS with “
FENCE,OFF#
”
SOS Alarm
The GPS Tracker includes a covert SOS button that can be attached in a suitable location for the
driver or passenger to activate in an emergency.
In the event of an emergency, press the SOS button for approx. 5 seconds and the GPS unit will
send a preset SMS message to the configured SOS numbers.
Following the SMS, the GPS unit will then call each of the configured SOS numbers, looping
through them up to 3 times until the call is picked up.
Set the Center Number to be used with Fuel Cut off
This number is configured to be the only number that can activate/deactive the fuel cut off so it
must be set prior to using the Fuel or Power cut off commands
Note: Only a configured SOS number can be used to set the Center Number
Send an SMS with “
CENTER,A,MobileNumber#
” (eg CENTER,A,0400123456#)
To remove the Center Number simply send an SMS with “
CENTER,D,#
”
