Simple Wiring
The GPS Tracker will function and communicate location information with just the 12 volt positive and
negative wires connected with the main plug. This is the simplest installation and handy if you need to
quickly connect the GPS but don’t have time to wire in all functions, or if you just want a simple to use
tracker.
Referring to the above wiring diagram, connect the Red and Black wires to a 12 volt (Fused Red
wire) and Ground (Black wire) location on the vehicle.
It is recommended to also wire the Orange wire to an accessory triggered wire. The ACC ON and
OFF function is used for some GPS functions such as timer based online tracker uploads (eg you
can set a different interval when the car is on vs when it is off).
Note, these do not have to be connected to the battery as per the diagram, they are shown this
way in the diagram just to represent the type of connection.
You can possibly connect them to a 12v source that can handle the additional capacity using its
existing fuse if you have such a connection available.
Advanced Wiring
The advanced functions of the GPS are a little more complex to install and may require you to locate the
fuel pump wiring in your vehicle which will require removing of the interior trim.
Note:
It is very likely you will need to extend the wires on the Relay Plug
Note:
The wiring of the fuel pump relay will depend on your vehicle and how the fuel pump is
triggered. Many vehicles are triggered by completing the ground circuit rather than supplying 12
volt. You will need to adjust the wiring to suit a ground triggered application if applicable.
Again,
be careful here as supplying 12 volt to a Ground circuit will cause you all sorts of problems.
Fuel Cut Off
o
Locate the fuel pump wiring in your vehicle. How the fuel pump is activated will depend
on your vehicle, however this is generally simplest to tap into the wiring either at the
fuel pump relay or the fuel pump itself.
If you are not confident doing this wiring,
please seek the assistance of an auto electrician.
o
Yellow wire – Connect the Yellow wire from the GPS Tracker plug to the Yellow wire on
the Relay Plug
o
Green wires – The Green wires on the Relay Plug intercept the signal given to the fuel
pump by the car when triggered by the GPS Tracker. You need to locate the fuel pump
wire and cut it. Connect each side of the cut to each of the Green wires on the Relay
Plug, thus creating a continuous circuit via the relay.
o
White wire – The white wire on the Relay Plug is connected to a fused 12 volt source to
trigger the relay when activated by the GPS Tracker.
