16
6.2 Replacing the ba
ffl
e/exhaust
de
fl
ector
Fig. 22
A
1. First remove the side burn plates (
Fig.4
). It is not necessary
to remove the back burn plate .
2. Pull the ba
ffl
e (
Fig. 20B
) forward and down at the front
edge. Turn it so that it is standing diagonally behind the
front, and lift it out.
3. Lift the back edge of the exhaust de
fl
ector (
Fig. 22A
), push
it backwards and then down at the front edge.
4. To install them, follow the same procedure in reverse order.
7.0 Maintenance
7.1 Cleaning and soot removal
Soot deposits may build up on the internal surfaces of the
fi
replace during use. Soot is an insulator and will therefore
reduce the
fi
replace’s heat output. If soot deposits accumulate
when using the product, they can easily be removed by using
a suitable detargent.
In order to prevent a layer of water and tar from forming in the
fi
replace, you should regularly allow the
fi
re to burn hot in order
to remove the layer. Your product should be cleaned internally
once a year to ensure the best heating e
ff
ect. It is a good idea
to do this when cleaning the chimney and
fl
ue pipes.
7.2 Sweeping the
fl
ue pipe to the
chimney
Flue pipes must be swept through the
fl
ue pipe sweeping hatch
or through the door opening. The side burn plates, ba
ffl
e and
exhaust de
fl
ector must be removed
fi
rst (see Chapter 6.2).
Sweeping the heat exchanger.
To clean the heat exchanger, remove the side burn plates,
ba
ffl
e and exhaust de
fl
ector
(see Chapter 6.2)
. Put on a
protection-glove and clean all surfaceswith a small brush
(bottle cleaner is recomended).
7.3 Inspection of the
fi
replace
Jøtul recommends that you carefully inspect your
fi
replace
yourself after it has been swept/cleaned. Check all visible
surfaces for cracks. Also check that all joints are sealed and
that the gaskets are in the correct position. Any gaskets showing
signs of wear or deformation must be replaced.
Thoroughly clean the gasket grooves, apply ceramic glue
(available from your local Jøtul dealer) and press the gasket
well into place. The joint will dry quickly.
7.4 Exterior maintenance
Painted products may change colour after they have been used
for several years. The surface should be cleaned and brushed
free of any loose particles before new paint is applied.
ENGLISH
