JOOLCA HOTTAP – MODEL JCA11001 USER GUIDE
11
The unit starts
for a short
amount of time
and then shuts
off.
Check for sufficient water flow and pressure. The unit must have a minimum of
45kPa of sustained water pressure and at least 4LPM to activate the burners.
Do not expose the water heater to strong winds as this may cause the flame to
blow out.
Water is not hot
enough.
Adjust the gas regulator and water regulator to meet your desired temperature. To
increase temperature; turn the gas regulator control from minimum to maximum
and turn the water regulator control from maximum to minimum.
Check source water temperature. If the source water temperature is too cold then
you may need to ‘cycle’ the water through the system back into the source reservoir
then through the appliance again to meet your desired temperature.
Check if there is a blue flame in the ‘viewing window’. If you see a yellow flame it
could mean a breakdown in the gas regulator - immediately shut down the unit.
Please call Joolca Customer Service directly if this happens,
DO NOT
attempt to use
the appliance.
