56
- 76
minimate
plus
31
32
3mm
33
2
1
3
4
Fig. 31: Wash the mesh under running
hot water and dry it thoroughly with a
non-fraying cloth.
Do not put back the mesh
on the ionising tube if it is
even partially wet.
Fig. 32: Put the outer metal mesh
back on the glass tube so that it fully
overlaps the internal plate.
In any case ensure a
minimum distance of at
least 3 mm from the base
of the tube.
Check that the earthing spring
is in contact with the outer
mesh once the ionising tubes
have been screwed back into
place. Otherwise contact the
manufacturer.
ATTENTION: do not
overtighten the screw after
reaching its end stop.
Fig. 33: Gently screw the tubes
ionizing by grasping them at the base (part
green). If the operation is difficult to
perform, pull slightly the earthing spring so
that it is not in contact with the surface of
the tube.
Repeat the same procedure
also for the other tubes
ionizing.
Summary of Contents for minimate plus
Page 74: ...74 76 minimate plus NOTES...
Page 75: ......
