Jonix maximate, Use And Maintenance Manual

Page: 14 / 44

14
JO NIX
maximate
230 VOLT
ALIMENTAZIONE ELETTRICA
POWER SUPPLY
SPANNUNGSVERSORGUNG
230V/3/50Hz
01
02
Before making any connections, make sure the mains voltage complies with what
is shown on the label.
The ON/OFF switch indicates when the device is powered.
WARNING!
it will take some minutes for the display to load the software correctly. When the
device is turned on the display might appear to be turned off.
Fig. 01: Connect the unit to the mains
using the power cable provided.
Fig. 02: Once connected to the mains
supply, the
JO NIX
maximate
module
is ready to work. In order to turn on the
device act on the selector (positioned on
the panel) turning it to I.
6.6 USING THE DEVICE
The control and the setting of functions is set using the Display (see chap. "Technical
Data" and "User interface and menu navigation".
Air flow rate (m 3 /h) No. of ionising modules on
3000 8
The module is set with the following
default parameters:
6.7 DEFAULT SETTINGS
ATTENTION!
Use the cable supplied for connection to the mains or use one with the same
section always made up of F, N and T.
ATTENTION!
It is recommended to check that the energy delivered is stable. Otherwise, a
voltage stabilizer must be installed upstream.
NOTE: the straight plug(A) is
located in the top exit. The
straight connector(B) comes
supplied.
B
A