Jonix 70JONIXUPIN, Use And Maintenance Manual

Page: 48 / 60

48
JO NIX
up in
If a malfunction other than that described above occurs, contact the Manufacturer
or a Distributor and always quote the part number and serial number on the
nameplate of the device.
11.2 GENERAL DIAGNOSTIC PROVISIONS
11.1 DIAGNOSTICS
PROBLEM POSSIBLE CAUSE SOLUTION
The yellow led
indicating the
operation of the
device is off.
Lack of power to the
device.
Check that the 0/I switch is in position I.
Check that the electrical connection is correctly made.
Check that power is present in the distribution mains.
Check that the electronic card inside the device is not
damaged. In this case contact the Manufacturer or
distributor.
You can't hear the
ionizer sizzle.
Ionizing tube failure.
Follow the instructions in section “10.3 - SPECIAL
MAINTENANCE”.
Need for maintenance to
the ionizing tube. Follow the instructions in section “10.2 - ROUTINE
MAINTENANCE”.
Air ionization
does not meet
expectations (lack
of ionizing effect
in the air).
The device settings are not
correct with respect to the
characteristics and volume
of the room to be treated. Refer to the table in section 6.7 "DEVICE USE" and
section 8.2 "MANAGED COMPONENTS, OPERATING
LOGIC AND FACTORY SETTINGS" to check the ionization
function and fan speed.
Need for maintenance to
the ionizing tube. Follow the instructions in section “10.2 - ROUTINE
MAINTENANCE”.
Fan failure.
Follow the instructions in section “10.3 - SPECIAL
MAINTENANCE”.
The optional EVO
display is off. Problem with the display
power supply line.
Check that the display is correctly connected to the
power line and that no electrical safety systems have
intervened.
11
- CHECKING OPERATION AND POSSIBLE FAULTS (DIAGNOSTICS)
Disconnect the power supply to the device and contact the Manufacturer or a dealer for assistance
even in the event of a malfunction, even if all procedures in this Operation and Maintenance
Manual have been performed correctly.
This section summarises the most common problems that may arise when using the unit. Before
contacting customer service, make the checks described in the paragraph on diagnostics and
check that the alarm led (red led) is not on.