Jonix 70JONIXUPIN, Use And Maintenance Manual

Page: 19 / 60

19
JO NIX
up in
Power cables are NOT supplied with the device.
6.5 ELECTRIC POWER SUPPLY
The JO NIX
up in
device is equipped with a dedicated line at the electronic board. Specialized
and authorized personnel of the user must pass a power cable of suitable section composed of
F, N and T inside the unit and connect it to a thermal-magnetic circuit breaker as shown in the
attached wiring diagram.
ATTENTION!
It is recommended to check that the energy delivered is stable. Otherwise a voltage
stabilizer must be installed upstream.
ATTENTION!
Provide the connection to the network with a cable of suitable section composed
of F, N and T.
ATTENTION!
Electrical connections must be carried out by qualified and authorized personnel.
ATTENTION! BEFORE STARTING ANY OPERATION, MAKE SURE THAT THE GENERAL
POWER SUPPLY LINE IS DISCONNECTED AND THAT THE DEVICE CANNOT BE
ACCIDENTALLY POWERED!
6.4 ELECTRICAL CONNECTIONS
• The electrical mains of the JO NIX
up in
device must be used for the device only, there must
be no other devices connected to the same power line. Do not use adapters, power strips and/
or extension cords.
• Make the connection with cables of suitable section in relation to the power input and in
compliance with the regulations in force.
• The installer must see to it to assemble the device as close to the power disconnector as
possible, according to standards in force and as far as necessary to protect the electrical
parts.
• Connect the device to an effective earthing outlet.
• The electrical connections must be carried out following the instructions provided in this
manual.
• Make sure that voltage and frequency of the electric line correspond to those provided on
the name plate.
ATTENTION!
Using a power supply that does not meet the requirements of the device may result
in damage to the device or some of its parts.
Before making any connections, ALWAYS make sure the mains voltage complies
with what is shown on the plate.