Page 10 XBase 09 Operating Manual
3.3 To Programm patterns into the XBase-09 (the real fun!)
Here's where the real fund begins:
Make sure the machine is in Pattern mode (Patt light is on). Make sure the Bass Drum, Snare
Drum and Hi Hat volumes are up, and the Master Volume control is up.
Hit the „Start" button.
(If you follow the directions carefully, you should never(!) have to hit the „Stop" button!)
Using the Up/Down keys, scroll to a Pattern number where this is no data... you'll know when
you've reached an empty Pattern when you hear no sound (brilliant!). Try above Pattern 30 to find
an empty one.
Hit the Write button (Write button will light up). Notice that the Bass Drum pad is blinking. This
means you're ready to Programm the pattern of the Bass Drum.
By pushing the various 16 red „Note Buttons 1, 5, 9 and 13 will give you a Bass Drum hit on
every quarter note. For our Pattern, choose 1, 5, 8, 9, 11, 14 and 16.
Now hit the Snare Drum pad (the lights blinks next to it, telling you the machine is ready to
Programm where the snare will play). Now hit the Note Buttons where you would like the snare
to play. (Tor this pattern, push Notes 1, 3, 4, 5, 7, 8, 9, 11, 13, 14, 15 and 16)
Hit the Closed Hi Hat pad (light blinks), and Choose where you want it to play (try 7, 11, 15),
Now that the Kick, Share and Hat are playing, adjust their individual volumes to your taste.
NOW... hit the Snare Drum pad again. Hit the Accent pad (accent button flashes along with snare
button light). Notice that all of the Note lights disappear. This is because you have not yet chosen
any snare notes to be „accented" (louder volume). For a note to be Accented, it must already be
chosen to play normally.
To remember which Snare notes you've previously chosen to play normally, simply hit the Accent
pad again (accent light goes out) and the Note buttons will light up where you have normal snares
programmed. Hit the Accent pad again (Accent light flashing).
Choose some of the Snare notes to accent. Try 5, 8, 13, 14, 15 and 16. Adjust the Accent level by
using the Accent volume control (upper right of the machine). Hit the Accent pad to come out of
Accent mode.
You may hit either the Bass Drum pad or the Closed Hat pad, then hit the Accent pad so that the
Accent light is flashing and set either Kick notes or Closed Hat notes to be accented also.
... Now, are you ready for the next level?
Now let's edit the sounds in this pattern.
„Solo" the Bass Drum by turning down the Snare and Hat volume controls.
Push the Bass Drum pad and -while holding it down- push the „Write" button (both Bass Drum
pad and Write button are blinking). Perhaps the sound of the Bass Drum has now changed... this
is because the Bass Drum sound knobs have been activated.
Now start turning the Bass Drum sound controls (labeled Tune, Pitch, Decay, etc). Keep turning
until you find a sound you like. That sound is now being written into the Pattern. Hit the „Write"
button once to deselect it. Hit it once again so the Write light is on, but not blinking. We do this
so that we can now change the sound of INDIVIDUAL Bass Drum notes, as opposed to ALL of
them.