minnkotamotors.com | 27
©2018 Johnson Outdoors Marine Electronics, Inc.
ROUTING CONNECTION CABLES
Please follow these instructions for routing any and all of the cables present for any of the pre-installed features that may come with your
trolling motor. This routing should be followed whether there are one or two connection cables present. If you are unsure of the cables
present, please review the “Identifying Trolling Motor Features By Their Associated Cables” section of these Installation Instructions.
ROUTING CONNECTION CABLES
a. Place the motor in the deployed position.
b. Locate the Built-in MEGA Down Imaging, i-Pilot Link
and/or Universal Sonar cable(s), at the base of the
Control Head.
c. The cable(s) should be fed all the way through the Coil
Cord. It/they should exit the Coil Cord at the bottom of
the Coil Cord, where it connects to the Mount.
CAUTION
Not following the recommended wire routing for the Built-in
MEGA Down Imaging, i-Pilot Link and/or Universal Sonar
cable(s), if equipped, may cause damage to the product and
void your product warranty. Route cables away from pinch
points or other areas that may cause them to bend in sharp
angles. Routing the cables in any way other than directed may
cause damage to the cables by being pinched or severed.
1
2
Control Head
Coil
Cord
Mount
Control
Head
Coil Cord
Mount
Built-in MEGA
Down Imaging or
Universal Sonar
i-Pilot Link
One Connection
Two Connections
Built-in MEGA
Down Imaging or
Universal Sonar
NOTICE:
Universal Sonar connector shown for
illustration purposes.
CAUTION
Do not over tighten the cable ties as it may damage the wires.
Control
Head
Coil
Cord
i-Pilot
Link
Control
Head
Coil
Cord
Built-in MEGA
Down Imaging or
Universal Sonar
One Connection
Two Connections
Built-in MEGA
Down Imaging or
Universal Sonar
d. Use a tie wrap cable to secure the cables to the top
of the Coil Cord, leaving only enough slack to let the
cables hang comfortably.
i-Pilot
Link
Tie Wrap
Cable
Placement
Tie Wrap
Cable
Placement
