20 | minnkotamotors.com
©2018 Johnson Outdoors Marine Electronics, Inc.
ORIENTATE THE PEDAL CONTROL SLEEvE ASSEMBLY FOR A STARBOARD MOUNT
Cable
Anchor
Steering
Cables
Screws
Wrap Drum
g. The Cable Anchor functions to hold the Steering
Cables in place. The cables run from the Cable
Anchor and wrap around the Wrap Drum. The Cable
Anchor is secured to the Steering Module with two
screws. Remove the two #10-32 x 1/2" screws that
hold the Cable Anchor in place using a #2 Phillips
screwdriver.
h. The Wrap Drum is set on the shaft of the Cable Gear
that extends above the Steering Module. The female
end of the electric wire passes out the top of the
Cable Gear. The shaft of the gear that the Wrap Drum
sits on is splined. To rotate the Pedal Control Sleeve
Assembly, the Wrap Drum needs to be lifted off of
the Cable Gear. Before the Wrap Drum can be lifted
or aligned, the Steering Cables should be loosened.
i. Once the Cable Tension Screw is loosened, and the
screws are removed, carefully pry the Wrap Drum
partially off by prying straight up, using a heavy
flat-blade screwdriver. The Wrap Drum should only
be lifted far enough up on the Cable Gear to rotate
the Pedal Control Sleeve Assembly to the inboard or
desired position. The Cable Anchor is in the correct
position on the mount when it is mounted towards
the inboard side of the mount.
NOTICE:
The top of the Wrap Drum has rounded and
smooth edges. The bottom of the Wrap Drum is flat
and the teeth that engage the Cable Gear are visible in
the center.
Cable Gear
Flat
Screwdriver
Steering
Cables
Wrap Drum
Cable
Anchor
CAUTION
Only pry the Wrap Drum high enough on the Cable Gear
to rotate the Cable Anchor and Pedal Control Sleeve
Assembly to the correct position. If the Wrap Drum becomes
unintentionally disengaged from the Cable Gear, the
Steering Cables can become unwound and will need to be
reassembled correctly for proper operation.
5
6
