minnkotamotors.com | 17
©2018 Johnson Outdoors Marine Electronics, Inc.
INDEXING THE MOTOR
Wrap Drum
Cover
Wires
Steering
Module
Screws
Cable
Anchor
Wrap Drum
Cover
Steering Motor
Connection Wire
k. Reconfirm that the Steering Cables are tight and
then carefully thread the Steering Motor Connection
Wire through the top of the Wrap Drum Cover. The
male plug comes from the Cable Anchor through
the opening at the bottom of the Wrap Drum Cover.
The wire with the female plug that runs out the top
of the Cable Gear should also be pulled through the
opening at the bottom of the Wrap Drum Cover.
l. Place the Wrap Drum Cover down on top of the Cable
Anchor and align the screw holes on it with the screw
holes on the Cable Anchor. Make sure the Wrap
Drum Cover is nested securely on top of the Steering
Module and that the wires pass out the top of the
Wrap Drum Housing. Secure the Wrap Drum Housing
in place with the two screws that were originally
removed using a #1 Phillips screwdriver. Tighten to
6 in-lbs.
Steering Motor
Connection
Plug
m. Reconnect the Steering Motor Connection Plug and
push it into the Wrap Drum Cover.
n. Orientate the wires connecting the Steering Motor
Connection Plug as noted so that the wires do not
touch moving parts.
o. Replace the Connector Cover.
Wrap Drum
Cover
8
CAUTION
Take care not to pinch the Steering Motor Connection Wire
while the Wrap Drum is set into place.
9
10
CAUTION
Wires and plug must not touch moving parts. Wires may be
damaged if caught in moving parts.
Wires