P00877Q
45
7.1 General
Check
0DNHVXUHWKDWWKH¿HOGVXSSOLHGHOHFWULFDOFRPSRQHQWVPDLQSRZHUVZLWFKHVFLUFXLWEUHDNHUV
wires, conduit connectors and wire terminals) have been properly selected according to the electrical
characteristics indicated in Table 7.1. Make sure that the components comply with National Electrical
Code (NEC) standards.
x
Supply electrical power to each outdoor unit. This equipment can be installed with a Ground Fault
Circuit Interrupter (GFCI), which is a recognized measure for added protection to a properly grounded
unit. Install appropriate sized breakers / fuses / overcurrent protection switches and wiring in
accordance to local, state and NEC codes and requirements. The equipment installer is responsible for
understanding and abiding by applicable codes and requirements. Failure to use a GFCI could result
LQHOHFWULFVKRFNRU¿UH
x
The power sources for the indoor unit and outdoor unit should be supplied respectively.
Connect the power supply wiring to each indoor unit group connected to the same outdoor unit.
This equipment can be installed with a Ground Fault Circuit Interrupter (GFCI), which is a recognized
measure for added protection to a properly grounded unit. Install appropriate sized breakers /
fuses / overcurrent protection switches and wiring in accordance to local, state and NEC codes and
requirements. The equipment installer is responsible for understanding and abiding by applicable
FRGHVDQGUHTXLUHPHQWV)DLOXUHWRXVHD*)&,FRXOGUHVXOWLQHOHFWULFVKRFNRU¿UH
(2) Check to ensure that the power supply voltage is within ±10% of the rated voltage.
If the power supply voltage is too low, the system cannot start due to the voltage drop.
(3) Check the size of the electrical wires.
(4) Communication cabling should be a minimum of AWG18 (0.82mm
2
), 2-Conductor, Stranded Copper.
Shielded cable must be considered for applications and routing in areas of high EMI and other sources
of potentially excessive electrical noise to reduce the potential for communication errors. When shielded
cabling is applied, proper bonding and termination of the cable shield is required as per Johnson Controls
guidelines. Plenum and riser ratings for communication cables must be considered per application and
local code requirements.
x
In an instance where the power source for the packaged air conditioner is supplied from the same
power transformer as the device with high electricity consumption*
x
In an instance where the power supply wiring for the device* and for the packaged air conditioner are
located close to each other.
([DPSOH/LIWFRQWDLQHUFUDQHUHFWL¿HUIRUHOHFWULFUDLOZD\LQYHUWHUSRZHUGHYLFHDUFIXUQDFH
electric furnace, large-sized induction motor, and large-sized switch.
In the instances mentioned above, an induction surge of the power supply wiring for the packaged air
conditioner could occur due to a rapid change in electricity consumption of the device and activation
RIWKHVZLWFK7KHUHIRUHFKHFNWKH¿HOGUHJXODWLRQVDQGVWDQGDUGVEHIRUHSHUIRUPLQJHOHFWULFDOZRUNLQ
order to protect the power supply wiring for the packaged air conditioner.
(5) Check to ensure that the ground cable for the outdoor unit, and indoor unit are connected.
7.2 Electrical Wiring Connection
Ɣ 7KLVHTXLSPHQWFDQEHLQVWDOOHGZLWKD*URXQG)DXOW&LUFXLW,QWHUUXSWHU*)&,ZKLFKLVD
UHFRJQL]HGPHDVXUHIRUDGGHGSURWHFWLRQWRDSURSHUO\JURXQGHGXQLW,QVWDOODSSURSULDWHVL]HG
breakers / fuses / overcurrent protection switches and wiring in accordance to local, state and NEC
codes and requirements. The equipment installer is responsible for understanding and abiding by
DSSOLFDEOHFRGHVDQGUHTXLUHPHQWV)DLOXUHWRXVHD*)&,FRXOGUHVXOWLQHOHFWULFVKRFNRU¿UH
Ɣ 3HUIRUPWKHHOHFWULFDOZRUNDFFRUGLQJWRWKHUHJXODWLRQVRIHDFKUHJLRQDQGWKLVLQVWDOODWLRQDQG
maintenance manual. A separate, dedicated electrical circuit must be used. If the electrical wiring
work is performed incorrectly or there is a capacity shortage of the power circuit, it will cause an
HOHFWULFVKRFNRUD¿UH
Ɣ &KHFNWKDWWKHJURXQGZLUHLVVHFXUHO\FRQQHFWHG,IWKHXQLWLVQRWFRUUHFWO\JURXQGHGLWPD\OHDG
to an electrical shock.
'RQRWFRQQHFWWKHJURXQGZLULQJWRJDVSLSLQJZDWHUSLSLQJOLJKWLQJFRQGXFWRURUWHOHSKRQH
ground cables.
Summary of Contents for (H,Y)VAHP072B31CW
Page 2: ......
Page 6: ......
Page 79: ......
Page 80: ...P00877Q Code No LIT 12012285 Issued March 2016 2016 Johnson Controls Inc ...