FX-WRZRMT10K-0 Wireless Remote Temperature Transmitter Installation Guide
6
2. Set the DIP switches located on the back of the
transmitter.
For a
mesh network application using an
FX-ZFR1811 Router
(Figure 5), set the
DIP switches as indicated. Refer to the
FX-ZFR Series Wireless Field Bus System
Technical Bulletin (LIT-12011660)
for information
on commissioning multiple FX-WRZRMT10K-0
Wireless Remote Temperature Transmitters in an
FX-ZFR1800 Series Wireless Field Bus System.
a. Set the
POWER
switch to
OFF
.
b. Set the
MODE
switch to
Mesh
.
c. Set the
PAN OFFSET
switches according to
the job or system plans.
d. Set the
ZONE
DIP switches to match the
Zone Number in the Facility Explorer Controller
Configuration Tool (CCT) software. Each Zone
Number corresponds to the SA Bus Address
as shown in Table 1.
e. Set the
MSTP ADDRESS
DIP switches to
match the MS/TP address of the controller with
which the transmitter is intended to
communicate.
f.
Set the
TRANSMIT LEVEL
switch to
10mW
.
For a
non-mesh network, One-to-One
application using an FX-WRZ7850-0 Receiver
(Figure 6), set the DIP switches as indicated,
ensuring that the
AREA
and
TRANSMITTER ID
switches on the FX-WRZ7850-0 Receiver and the
FX-WRZRMT10K-0 Wireless Remote Temperature
Transmitter(s) are set to the same value.
a. Set the
POWER
switch to
OFF
.
b. Set the
MODE
switch to
1 to 1
.
c. Set the
SENSOR #
to
199
for applications with
only one transmitter per controller. Use the
other settings for additional transmitters in
applications with a single controller. Refer to
the
One-to-One Wireless Sensing System
Technical Bulletin (LIT-12011663)
for
information on commissioning multiple
FX-WRZRMT10K-0 Wireless Remote
Temperature Transmitters in an
FX-WRZ7850-0 One-to-One Wireless Room
Temperature Sensing System.
d. Set the
AREA
switches to match the
AREA
switch on the FX-WRZ7850-0 Receiver.
e. Set the
TRANSMITTER ID
switches to match
the
TRANSMITTER ID
on the FX-WRZ7850-0
Receiver.
3. Install two AA alkaline batteries (supplied) into the
battery compartment on the back of the transmitter.
Ensure that the batteries are installed in the proper
polarity (Figure 7).
IMPORTANT:
Ensure that the
PAN OFFSET
is
the same for each FX-ZFR1810 Coordinator,
FX-FR1811 Router, and FX-WRZRMT10K-0
Wireless Remote Temperature Transmitter in a
mesh network.
Figure 7: Back of FX-WRZRMT10K-0 Wireless
Remote Temperature Transmitter Showing
DIP Switches and Batteries
AA Alkaline Battery
AA A
lkalin
e Bat
tery
Insert two AA alkaline
batteries in battery
compartment.
F
IG
:b
ck_w
rz
_s
tr
00
00_
0
Place
DIP switch
overlay
here.
Table 1: Setting the ZONE DIP Switches
Zone Number
SA Bus Address
0
199
1
200
2
201
3
202
4
203
5
204
6
205
7
206
8
207
