FX-WRZRMT10K-0 Wireless Remote Temperature Transmitter Installation Guide
5
3. Remove the terminal block from the circuit board.
4. Secure the wire ends to the terminal block using a
1/8 in. (3 mm) blade screwdriver. The
recommended torque is 3 lb ft (4 N·m).
Note:
The wiring connections on the terminal block
are interchangeable.
5. Reinstall the terminal block onto the circuit board
Preparing the FX-WRZRMT10K-0 Wireless
Remote Temperature Transmitter for
Operation
To prepare the FX-WRZRMT10K-0 Wireless Remote
Temperature Transmitter for operation, and to reinstall
the transmitter housing on its mounting base:
1. Place the appropriate DIP switch overlay (based
on the application) over the DIP switches. See
Figure 5 through Figure 7.
IMPORTANT:
Do not power up the
FX-WRZRMT10K-0 Wireless Remote
Temperature Transmitter until a receiver or controller
is installed and operating within the same Radio
Frequency (RF) range. If this condition is not met,
the transmitter uses a higher-than-normal battery
current as it attempts to find a receiver or controller
within range, resulting in reduced battery life.
Figure 4: Connecting the TE-6300 Series
Temperature Sensor to the FX-WRZRMT10K-0
Wireless Remote Temperature Transmitter
FIG
:pr
b_
w
rn
g
Figure 5: Mesh Network Application
DIP Switch Overlay
FI
G
:z
fr
1811
_m
sh
Figure 6: Non-mesh Network,
One-to-One Application
DIP Switch Overlay
FI
G
:w
rz7
8xx_
non
_m
sh
