Wireless Remote Controller
DRCR
3
6
SWING
UP/DOWN
B
utton
●
Press this button to set up the swing angle, which
sequentiall
y changes as
shown
.
●
When the guide louver starts to swing up and down, if SWING funtions
is canceled, the air guide louver will stop and remains at the current
position.
●
indicates the guide louver swings up and down among those five
directions.(Simplified SWING function applicable for some
fan coil u
nits
.
When the wireless remote controller is energized initially with the unit
under the OFF status, it should be set by pressing the + button and the
SWING button simultaneously, with the symbol blinking twice. Then,
after the unit is turned on, this function can be activated by pressing the
SWING button, with the displayed symbol indicating swing function is
on and without this displayed symbol indicating swing function is off.)
7
CLOCK
B
utton
●
By pressing this button, the clock is allowed to be set, with
blinking,
and then press the +/- button to adjust the clock within 5 seconds. If
the
+/-
button is pressed down
continuously
for more than 2 seconds,
the
clock setting will be increased or decreased
by
10 minutes every
0.5
seconds. After that, another press on the CLOCK button accepts
the
setting. 12:00 is the default, when the wireless remote controller
is
energized.
8
TIMER ON
B
utton
●
When TIMER ON is activated, ON will blink while the symbol will
disappear. Within 5 seconds
,
set the ON time by pressing the +/-
button. Each press will make the time increase or decrease
by 1
minute.
The
time can
also
be set by pressing
and holding
the +/-
button
.
With
in the
first
2.5 seconds, the time will increase/
decrease quickly
by
minute, and in the
next
2.5
seconds
, the
time
will increase/decrease
by 1
0
minutes. After the desired
time value
is set,
press
TIME
ON again to conform the setting within
5
seconds
.
After
that, another press
of
TIMER ON will cancel the
setting.
Prior to this setting, the clock
should
be set to the actual time.
9
X-FAN
B
utton
●
Pressing this button can activate or deactivate the X-FAN function.
In Cool or Dry mode, by pressing this button,if "
" is displayed, it
indicates the X-FAN function is activated. By repressing this button,
if "
" disappears, it indicates the X-FAN function is deactivated.
Upon initial power up, the X-FAN function is defaulted to OFF.
If the unit
is turned off, X-FAN can be deactivated but can't be activated.
Summary of Contents for DRCR
Page 13: ...6 ...
