32
P5417055
Trouble
Action before Contact
Protection devices (fuses, breakers, and GFCI's) activate
frequently or the operation switch does not work.
Turn OFF the power source.
Water leakage from the indoor unit.
Stop the operation.
"Motion Sensor ON" or "Radiation Sensor" is flashing.
There is a possibility of the failure of motion sensor
or radiation sensor.
Make the setting of motion sensor and
“
Floor HEAT
Control
”
invalid and contact your distributor. In
that case, after the LCD of wired controller display
has disappeared and until service is finished, the
operation of this unit is available.
● The RUN indicator (red) is flashing.
● The indoor unit number, alarm code, unit model code,
and the number of connected indoor units are displayed
on LCD.
● If multiple indoor units are connected to one controller,
the above abnormality informations for each indoor unit
are displayed individually.
Check the details on LCD and contact your distributor.
Refer to Section 8.4, the alarm code table.
Contact your distributor and inform them of the alarm
code indicated on the LCD of the wired controller.
Provide the following information when contacting your distributor.
1) Unit model
2) Symptoms and nature of the problem.
3) Number of the alarm code or any flashing indicator on the LCD.
8.3 Contact Distributor
If trouble still persists, even after checking off previously listed items or detecting problems not mentioned in
the previous pages, stop using this product and call your distributor or contractor immediately.
If there is any perceived abnormality present (noises or odors associated with electrical short,
fire, or burning elements), shut down immediately and shut OFF at the main power source.
Contact your distributor or contractor without delay.
Sel.
OP MODE
I.U.
: RCI-3.0FSN3
MODEL : F .08
Alarm Code:
23
Indoor Unit Number
O.U.
: RAS-3HVRNM2
01-02
AlarmRST
Address
Entr
IDU
: ******
ODU : ******
Chek
OK
