- 34 -
User Guide
JVC65RBTN
T R O U B L E S H O OT I N G
Plug the switch
Replug the switch
Empty the tank
Clean the filter
Replace the valve
Replace the solenoid valve
Replace the switch
Recharge or replace the battery
Find the short circuit and activate
the overload protection
Find the short circuit and activate
the overload protection
Check the connections
Connect correctly
View the error code
Replace the switch
Plug back the connections
Replace the motor
Replace the wheels
Adjust the nut
of the brush
Replace the switch
Replace the switch
Problem
Causes
Solutions
The machine
does not
work
The machine
does not move
forward
Charge
break
Engine
break
Breakage of
vacuum
engine
Lack of
cleaning
solution
Nut of the brush
poorly adjusted
Damaged switch
Flatten or damaged battery
Overload protection unactivated
Overload protection unactivated
Bad connection
Disconnected power cable
Bad connection
Charger breakage
Button is damaged
Motor damaged
Broken wheels
The brush remains suspended
or the button is damaged
Damaged manual switch
Switch unplugged
Damaged engine
Tank full
Blocked tank filter
Damaged water valve
Damaged solenoid valve
Be sure to follow these guidelines when transporting the machine from place to place by truck or
on a trailer.
TRANSPORT THE MACHINE
If the machine is disabled, it can be pushed from the front or rear, but you can not tow it from the front.
FOR SAFETY:
DO NOT operate the machine when brake is disabled.
Only push or tow the machine on a level surface at a speed no more than 3.2 kp/h (2 mph).
DO NOT push or tow the machine at a high speed.
Release the manual brake lever before pushing or towing the machine.
PUSH OR TOW THE MACHINE
Be certain to follow the procedures below when transporting the machine by trailer or truck:
1. Raise the squeegee assembly and the brush motor.
FOR SAFETY:
Drain the tanks before loading/unloading the machine on to/off a truck or trailer.
2. Load/unload the machine using recommended equipment.
FOR SAFETY:
A handling device is recommended to be used for loading/unloading the machine onto/off the
truck or trailer.
3. Fix the front of the machine close to the front position of truck or trailer.
4. Place a block behind each driving wheel to avoid machine sliding.
5. Fasten the rack of machine with ropes, then tie the ropes to the truck or trailer to prevent the machine
from inclining.
FOR SAFETY:
A rope should be used to fix the machine to the sweep template during transportation.
MACHINE STORAGE
For long time storage of the machine, follow the steps below:
1. Drain and clean the solution tank and recovery tank. Open the recovery tank for ventilation.
2. Park the machine at a cool, dry area, keep it away from rain, store it indoor.
3. Remove the battery set or charge it every three months (to full capacity).
FROST PROTECTION
FOR SAFETY:
Stop the machine at a level surface and turn it off before leaving or servicing.
1. Empty the water in solution tank and recovery tank.
2. Add 2 gallons (8 L) propylene glycol / recreational vehicle (RV) anti-freezing agent to the solution tank
without dilution.
3. Power the machine on, operate solution flow system. When anti-freezing agent flows to scrub head,
power the machine off.
