Malfunction
Possible cause
Possible solution
The mains plug is not connected in
the mains socket.
Connect the mains plug.
The fuse in the fuse box is
damaged.
Replace the fuse.
The delay start is set.
• Cancel the delay start.
• When the countdown is
completed, the washing
programme starts automatically.
Once the checks have been carried out, switch
on the appliance. The programme continues
from the point at which it was interrupted.
If the malfunction occurs again or the display
shows an alarm code that is not listed in the
table, please contact our extended warranty
administrators. Refer to 'Repairs - after sales
service'.
The washing and drying results are not satisfactory
The dishes are not clean.
The washing programme was not
applicable for the type of load and
soil.
Make sure that the washing
programme is applicable for the
type of load and soil.
You did not put the items correctly
in the baskets, water did not touch
all surfaces.
Put the items correctly in the
baskets.
The spray arms could not turn
freely. Incorrect position of the
items in the baskets.
Make sure that an incorrect
position of the items do not cause
the blockage of the spray arms.
The filters are dirty or not
assembled and installed correctly.
Make sure that the filters are clean
and correctly assembled and
installed.
The quantity of detergent was not
sufficient or missing.
Make sure that the quantity of
detergent is sufficient.
Limescale particles on the dishes.
The salt container is empty.
Fill the salt container with
dishwasher salt.
Incorrect level of the water
softener adjustment.
Adjust the water softener with the
correct level.
The salt container cap is not closed
correctly.
Make sure that the salt container
cap is closed correctly.
There are streaks, whitish stains, or
a bluish layer on glasses and dishes.
The rinse aid quantity is too high.
Decrease the rinse aid quantity.
Dry water drop stains on glasses
and dishes.
The rinse aid quantity is too low.
Increase the rinse aid quantity.
26 Dishwasher
user
manual
