The water softener must be set in two
ways, manually and electronically.
Setting manually
The appliance is factory set at position 2.
1. Open the appliance door.
2. Remove the lower basket from the
appliance.
3. Turn the water hardness dial to position 1
or 2. Refer to the water hardness table.
4. Replace the lower basket.
Setting electronically
The appliance is factory set at level 5.
1. Switch on the appliance. Make sure that the
appliance is in setting mode.
2. Press and hold function button (
B
) and
function button (
C
) simultaneously until the
indicators above function buttons (
A
), (
B
)
and (
C
) start to flash.
3. Release function button (
B
) and function
button (
C
).
4. Press function button (
A
), the indicators
above function buttons (
B
) and (
C
) go off
while the indicator above function button
(A) continues to flash. The display shows the
current level (e.g.
displayed = level 5 ).
5. To change the level, go on pressing function
button (
A
) until the display shows the
required level. Refer to the water hardness
table.
6. Switch off the appliance to confirm the
operation.
Filling with salt
Caution! Only use salt specifically
designed for dishwasher use. All
other types of salt, especially
table salt, will damage the water
softener. Only fill with salt just
before starting one of the
complete washing programmes.
This will prevent any grains of
salt or salty water, which may
have been spilt, to remain on the
bottom of the appliance for any
period of time and cause
corrosion.
1. Open the appliance door and remove the
lower basket.
2. Unscrew the cap of the salt container by
turning it anticlockwise.
3. Pour 1 litre of water into the container (this
is necessary only before filling with salt for
the first time).
4. Using the funnel provided, pour in the salt
until the container is full.
Dishwasher user manual
11
