vision
Snack Plus/Easy Combo
//
Vending
MNP86V03GBV00
Date: 2010/06/14 Rev. 0
PAGE 26 OF 62
5.6. Updating the machine program
The control card of the machine has been designed to use flash technology. This allows
you to update the program in the card without needing to remove any part of the
machine, as this task can be done through a 180 degree 5 pin DIN connector in the RS-
232 port. You can update the program with a PC or a J-120 reprogramming card reader.
■
USING A PC
Follow these steps to update the program:
1.-
With the machine turned off, connect the PC to the machine using the RS-232 cable.
2.-
Choose the program to install in flash memory:
•
The program files should be stored in the subdirectory of the hard drive
corresponding to the VISION V3 machine.
•
Run the PC program. Choose the menu option FLASH - RECORD - VISION V3
and choose the *.h00 file.
3.-
Turn the machine on.
4.-
When the program has been updated, a message will appear on the PC screen
indicating that the flash memory has been successfully recorded.
■
USING A J-120 REPROGRAMMING CARD READER
Follow these steps to update the program:
1.-
Insert the reprogramming card in the desktop card reader, which should be turned on.
2.-
Choose the program to install in flash memory:
•
The program files should be stored in the subdirectory of the hard drive
corresponding to the VISION V3 machine.
•
Run the PC program. Choose the menu option CARD – RECORD – VISION V3
and choose the *.h00 file.
3.-
Once the card has been recorded, take it out of the desktop card reader and insert it
in the reprogramming card reader.
4.-
With the machine turned off, connect the card reader using the machine's 180°, 5-pin
DIN connector.
5.-
Turn the machine on. First, the card reader's green LED will light up and then, while
the program is being recorded, the red LED and the green LED will blink.
6.-
When the program has been updated, the card reader's green LED will blink. At this
point you can disconnect the card reader from the machine.
■
USING THE EASYFLASH REPROGRAMMING DEVICE
Follow these steps to update the program:
1.-
With the machine turned off, connect the EASYFLASH device to the machine using
any of the cables supplied.
2.-
As soon as the program is loaded, it will load the data from the file TYPES.DAT for
the machines with which you wish to communicate.
3.-
The first thing the program requests is the type of operation you wish to carry out.
- Recording a program in flash memory.
- Erasing the card’s flash memory.
