Page | 14
CELLO
- User Manual v1.0
MUTE
– mutes the monitors
The faders control the master level fed to each of the outputs. For example pulling
down the ph-1 fader will reduce the overall volume in headphone 1 output.
AFL
– After fade listen buttons will reflect the respective mix onto the main monitor
outputs
The Monitor section also includes buttons for monitoring:
Stereo
,
Mono
,
Left
,
Right
,
Rev
erse which are hopefully self explanatory.
You are also able to select which output will be used as the main engineering mix
using the “
select PFL output
”
Main
– outputs any pre fade listen to the main monitor outputs
Ph1
– outputs any pre fade listen to headphone 1 outputs – useful if monitoring over
headphones
PH2
- outputs any pre fade listen to headphone 2 outputs – as above
Digi
- outputs any pre fade listen to the digital outputs (if any)
“
Talkback to mix
” selects which outputs you want to use for talkback.
Main
– talkback to the main mix
Ph1
– talkback to headphones 1
Ph2
– talkback to headphones 2
Digi
– talkback to the digital output
Slate
– send talkback to the DAW to slate a take
Autodim
– automatically DIMs the monitors when talkback is pressed
TB
– sel;ects which input to use as the talkback mic. Selectable between Mic1, Mic2
and the internal talkback mic
Saving and Recalling Mixes
The Menu button at the top left of the JoeCoControl panel (or the top menu bar on
your Mac) allows you to save and recall multiple mixes. This can be useful if you want
to try some experiment and then go back to where you were or if a vocalist has a
