CELLO
- User Manual v1.0
Page | 11
Top+
: adds a subtle high frequency lift to the mic channel. The turnover frequency
can be adjusted using the “+” button beneath or on the hardware interface by
pressing and turning the headphone 1 knob (or headphone 2 knob for channel 2)
Note that there is no onscreen level control on the Mic Pre and Instrument inputs.
The level control on these channels is via the physical control knob on the hardware
interface. This allows for a fully analogue signal path through these most sensitive
circuits. This keeps the signal path exceptionally clean without any digital
interference.
The other channels have on screen PAD buttons to reduce the input gain by 20dB
where needed.
The Talkback facility is activated by pressing the Line-In control knob on the
hardware. The white channel name “ 4 ” turns red when talkback is active. The
channel is muted when not in use.
Line in level can be adjusted using the hardware control or using the on screen
faders. The small “link” button at the top of the Line-in channels allows the left and
right level controls to be unlocked for rebalancing and can then be locked together
again to adjust the rebalanced signals.
Any digital inputs do not have adjustable input levels.
Each input will show up in your workstation according to its channel number (so Mic1
should show up as input 1, etc.. Use your DAW to route each input to its required
destination.
The blue buttons on the left side duplicate the buttons on the smaller input panel
Clock:
determines the clock source
Auto – determined by the digital input
Internal
Word Clock
Digital Input:
selects which digital input to use
Digital Input off
SPDIF coax (RCA socket)
SPDI Optical (TOSLINK i/p 1)
