JACOBSEN HR9016 Cab Operator Manual & Parts List
Jodale • Perry Printed: 4/4/2008
19
◄
TABLE OF CONTENTS
MOUNTING INSTRUCTIONS
3.
Replace oil cooler, by reversing step four from above.
Install floor shield (G) on
tractor. Insert prop rod into
hole in frame to hold oil
cooler in its regular position
(D) at bottom of cooler and
position hydraulic line to the
front of it. Swing cooler up
and toward radiator as
shown (E). Slide screen (B)
in front of oil cooler. Fasten
knobs (C) located on top of
oil cooler, and insert plastic
shield
(F) in front of oil
cooler. Attach end cap (A)
from left side of cooler.
4.
Finishing cab installation.
Fit pre-cut foot platform
floor mat (43) onto foot platform, and seat platform
floor mats to seat platform. If necessary, trim floor
mats to provide close fit to tanks, front of seat
assembly, steering tower and front cab frame
members. When fit of floor mat is satisfactory,
remove floor mat, apply adhesive to underside of
floor mat and reinstall. Use sealer to seal seams in
floor mat and between floor mat and tanks, and
wherever edges of floor mat meets seat platform,
tanks or cab frame. (See Figure Twenty-eight).
Reinstall door, right front window and side windows
by reversing the steps described in “Removing door
and windows”.
5.
Installing the step.
Remove the two bolts on the left
wing of the front deck, where the step fits under a
support bracket. Replace those bolts with two 3/8” X 1
1/2” hex bolts (46) supplied. Place step (47) over the
bolts, positioning it to the front and outside of the
original step. Secure into place using the nuts removed
from the support bracket.
Summary of Contents for Jacobsen HR9016
Page 1: ...Printed 4 4 2008 ...
