JACOBSEN HR9016 Cab Operator Manual & Parts List
Jodale • Perry Printed: 4/4/2008
16
◄
TABLE OF CONTENTS
MOUNTING INSTRUCTIONS
4.
With optional cab lift bracket only.
Install the cab lifting bar.
Pass the cab
lifting bar through the door opening and
the escape window opening (18).
Position the lifting bar against the front
surfaces of both hinge posts and slide it
upward so that the rubber padded
brackets hook around the inside of each
hinge post. Attach lifting bar to hoist,
ensuring that lifting bar, chains or cables
will not damage the cab roof. Remove
bolts securing cab to pallet. Lift cab with
hoist.
I
NSTALLATION
1. Attach a lifting strap to the brackets and raise the cab frame slowly over the
tractor.
2.
Lowering the cab.
Begin lowering the cab carefully onto the tractor, guiding the
rear mounts between the tanks. Ensure that fuel and oil filler spouts clear the cab
side panels. Ensure that the heater hose does not
become pinched under cab. Lower the cab until the
cab mounts are resting on the rubber isolators in the
front and rear bracket isolator cups. Insert the four
5/8” X 3 1/2” bolts (19) into the mounts from above.
From below, first slip on the rubber washer (20), then
the thick square structural washer (21), and finally
the 5/8” nut (22).
Warning
-
The structural washer is crucial to the
structural integrity of the ROPS frame. It must be
installed between the bottom surface of the mo
brackets and the nut. If it is not installed, the nut could be
pulled through the mounting bracket during a rollover, and protection would be lost.
Torque nut to compress isolator until the distance between top plate of bracket and
bottom plate of mount is 1 1/8”. (See figure 17). Torque 5/8” bolts through front surface
of front mounting bracket to 120-180 ft-lbs. Locate front left mounting bolt, an
floormat under cab frame crossmember, at the b
unting
d tuck the
ottom of the windshield.
3.
With optional cab lift bracket only.
Remove, but do not discard the cab lifting
bar. It may be required for future cab installations.
Summary of Contents for Jacobsen HR9016
Page 1: ...Printed 4 4 2008 ...
