JLG X20JPLUS, Operator, Safety, Maintenance And Service Manual

Page: 94 / 206

92 Boom Lift Models X20JPLUS
USING THE MACHINE MUX20JP021602
a Make sure that the specifications of the power line correspond to the voltage
and frequency indicated on the electric motor rating plate.
b Check the condition of the power cable; it must be sized for a rated power of
2.2 kW. Note that:
c In the case of the electric motor 230V to the network are required at least
3.9Kw. Use to connect a cable pole least ʺ 3x2.5mm2 ʺ with ground socket type F47,
double insulated with plug for at least 16A. The maximum cable length must be
10 m
d In the case of the electric motor 110V to the network are required at least
4.1Kw. Use to connect a cable pole least ʺ 3x6mm2 ʺ with ground socket type F47,
double insulated with plug for at least 32A. The maximum cable length must be
10 m
e Place an earth plate in the ground and connect it to the machine ʹ s ground
clamp or, if this is not possible, make sure the power connection is earthed (e.g.
indoors).
• Make
sure that all the emergency STOP buttons are released; this condition
can be checked on the remote control display, where no icon should appear in po ‐
sition 7 ʺ Fig. 43 Emergency stop pressed(p. 58) ʺ . If the operator attempts to start
the machine with the emergency stop button still pressed, an error message will
appear on the display when the start button is pressed.
• Use the button on the remote control to start the motor.
• If the operator attempts to start one of the two motors while the other is alre ‐
ady running, starting will be impossible and the icon showing the motor already
on will appear at the centre of the screen.
Fig. 86 Error, ignition attempt with stop pressed