MACHINE SET UP AND PACK UP
6308AN
8. Ensure that the light bar assembly
is clear to swing out and away from
its stowed position. Unlatch the
transport turnbuckles.
PRIOR TO RAISING THE MAST,
CHECK AND ENSURE THAT NO
OBSTRUCTIONS ARE LOCATED
ABOVE THE UNIT TO A HEIGHT
OF 10 METRES. REFER ALSO
TO SAFE DISTANCES FROM
POWER LINES AS DESCRIBED
IN SECTION 1 (SAFETY
PRECAUTIONS).
9. Slowly operate the light bar tilt
hydraulic lever and hydraulic
controls enable switch to move the
light bar forward, up and away from
the front of the tow hitch.
10. Operate the lift control lever and
hydraulic controls enable switch to
continue to raise the mast to full
elevation.
11. Operate the telescope lever and
hydraulic controls enable switch to
extend the mast to desired height.
12. Finally, adjust the light bar tilt to the
desired angle by operating the tilt
control lever and hydraulic controls
enable switch.
TO AVOID CRUSHING INJURY,
KEEP HANDS AND ARMS AWAY
FROM THE MOVING PARTS OF THE
MAST.
Turning Lights On
!
1. Start the engine by switching on the
ignition switch, turning the key
counter-clockwise to the Glow
Preheat position until the Glow
Light extinguishes and then turning
to the right to start the Engine.
Once started, allow the engine to
warm for a minute prior to using.
NOTE:
The Engine Distress
Shutdown system if installed
requires a build up of engine oil
pressure before the engine will
start. To overcome a delay in
starting, a momentary pushbutton
called “Start Override” is located on
the control panel below the Engine
Distress Light. Hold this button in
when cranking engine to start.
2. Switch on main circuit breaker.
Then switch on the light circuit
breakers 1, 2, 3 & 4 to activate
lights.
3. Allow lights to warm up and reach
full brightness (about 3 minutes).
NOTE:
The lamps used are a Metal
Halide Gas Discharge type. If they
are switched off and back on again
after they have been running they
may take up to 15 minutes to re-
ignite. This is normal for this type of
lamp.
!
Page 1-9