CONTROLS IDENTIFICATION
6308AN
CONTROLS IDENTIFICATION
Engine Control Panel
1. Ignition on – emergency shutdown
switch.
2. Service light switch for optional
cabin light.
3. Circuit breaker 15 Amp protects
D.C. control circuits.
4. Circuit breaker 20 Amp master D.C.
circuit protection.
5. Alternator warning light. This light
will illuminate if loss of alternator
charge is experienced.
6. On some units without an engine
shutdown system, this is a low
engine oil pressure warning light.
On units retrofitted with an Engine
Shutdown System this is an Engine
distress light indicating, low oil
pressure, low water level, high
engine temperature condition.
7. Keyswitch. Turn left for engine glow
preheat. The glow plug light will
illuminate and then extinguish after
a few seconds. Then turn the key to
the right to start the engine.
8. Glow plug light as described in item
7.
9. Hourmeter. Shows number of hours
that the machine has been on.
10. Engine shutdown timer module.
11. Timer duration selector switch.
12. Timer on/off switch.
13. Start Override Switch.
Engine Shutdown Unit
Located within the above control box is
an engine monitoring shutdown
system. In the event that one of the
following conditions should take place,
the engine will shutdown and illuminate
the Engine Distress Light.
1. Low oil pressure
2. Low water level
3. High engine temperature
Should a shutdown occur, the system
can be reset by turning off the ignition.
The fault should be corrected prior to
restarting.
Light Control Panel
1. A.C. Main Circuit Breaker and
Residual Current Device (R.C.D)
provides overload protection to all
A.C. circuits connected to the
Alternator.
2. Switch/circuit breaker for lights one
to four. Also protects against
overload on these lights.
3. R.C.D/circuit breaker for General
Purpose Outlet A.C. (G.P.O) option
when fitted.
1
2
5
3
4
10
6
7
8
9
1
2
3
11
12
13
Page 1-6